Thermaltake Pacific Core P6 DP-D5 Plus Distro Plate, With Pump Combo, 350ml Capacity, 3.5 Watts Power, 1135 L/h Max Flow Rate, 4 Pin Connector, G 1/4 Screw Thread, Black | CL-W344-PL00SW-A

Pacific Core P6 DP-D5 Plus is specifically designed for the Core P6 Chassis, and it is a Modder level reservoir integrated with a high-performance D5 pump.
Upgrade For Your Core P6 Chassis
It’s a distribution plate with a pre-installed D5 pump, the Thermaltake Core P6 DP-D5 can release the limit for Core P6 Chassis. It can perfectly integrate and upgrade your build. For those who are into RGB, it can be synced with Thermaltake RGB PLUS ecosystem and fulfil your request.
Vivid RGB Lighting from Every Angle
Controlled by the patented TT RGB PLUS 2.0 Software and the app, P6 DP-D5 Plus’s 18 LEDs light up the distro plate with stunning customizable RGB lighting
Spectacular RGB Illumination Design
It features 18 addressable LEDs with 16.8 million RGB colors. The lighting is compatible with TT RGB PLUS 2.0 and ASUS, GIGABYTE, MSI, and ASROCK RGB software.
Straightforward Installation
Core P6 DP-D5 Plus simplifies the tube structure of liquid cooling and delivers exceptional space savings for the Core P6 chassis.
High Quality 30mm Thickness PMMA
It not only has excellent pressure resistance to sustain the output up to 50 PSI (pounds per square inch) from the pump, but can also guarantee the overall product durability.
High-performance D5 Pump
High performance pump achieving 1135 L/hr and having a lifecycle of 50,000 hours MTBF.
TT RGB PLUS Ecosystem
Light up your system with almost limitless possibilities and synchronize your TT RGB PLUS compatible products to create a RGB ecosystem that is truly unique to you
Cautions
Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks
To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.
Thermaltake recommends the following steps to be taken after completing your water loop setup
It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
Fill the reservoir to the top as it will prevent air from going into the pump
If necessary tilt the system slightly from side to side to bleed the air out of the loop.
Place some paper towels under fittings and joining points to test for leaks.
Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
Coolant might fade over time.